Page 5 of 5
ASSEMBLY IS COMPLETED
Adjust the leveler according to the
ground level on Step 4.
Align the threaded end of the slat support leg (#7) with the pre-drilled
hole of the slat (#6) and tighten by hand until secured. Repeat the
process to assemble the remaining 3 slat support legs (#7) onto the 3
slats (#6)
Turn right (clockwise) to tighten
#E x 8pcs
I.
Align the ends of the assembled slat (#6) with the pre-drilled holes on
each side of the side rails (#5).
II. Secure two screws (#E) onto the ends of the slat (#6) by using a
Phillips screwdriver to tighten them down to the side rails (#5).
III. Repeat the process to assemble the remaining 3 assembled slats
(#6) onto the side rails (#5).
Adjust the leveler according to the
ground level. To lower or to raise the
slat support leg, you need to turn the
leveler clockwise or counterclockwise,
respectively.
X4
#6
#6
#7
Turn right (clockwise) to tighten
#1
#4
#5
#E
#6
#5
