Page
8
of
8
ASSEMBLY IS COMPLETED
I.
Prepare a bed slat using two slats (#7), one center connector
(#G) and two end caps (#H). See diagram for the correct
sequence in connecting those parts.
II.
Align the two end caps (#H) with the pre-drilled holes on each
side of the side rails (#3) and press firmly down on both end caps
(#H) to lock with the side rails (#3). Then press firmly down on the
center connector (#G) to lock with the support rail (#5).
III.
Repeat the process above to assemble the remaining bed slats
onto the side rails (#3) and the support rail (#5).
IV.
Make sure the bed is rested on a flat surface and does not feel
loose or wobbly. If it does, double check that the bolts/screws are
secured and properly tightened.
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
#G x 15 pcs
#H x 30 pcs
Summary of Contents for CM7689Q
Page 2: ...Page 2 of 8 ...
