Insert the threaded ends of the rail support legs (#9) into
the pre-drilled holes on the support rail (#8). Tighten by hand.
Adjust the leveler according to the
ground level. To lower or to raise
the slat support leg, you need to
turn the leveler clockwise or
counterclockwise, respectively.
I. Apply the slat kit (#7). Make
sure the pre-drilled holes align.
II. Prepare 2 bolt assemblies by
FIRST inserting the lock
washer (#F) onto the bolt (#E)
then the flat washer (#G) onto
that SAME bolt (#E). Insert into
the two slats that have a
centered pre-drilled hole and
secure using the Allen wrench
(#D).
