Furniture of America CM7296M, Assembly Instructions, Page: 4 / 4

With the help of another person, carefully place the dresser (#2) on its
back on a protected surface. Align the threaded end of the center leg
(#4) with the pre-drilled hole on the bottom center of the dresser (#2) and
tighten by hand until secured.
Page 4 of 4
Turn right (clockwise) to tighten
Adjust the leveler according
to the ground level. To
lower or to raise the center
leg (#4), you need to turn
the leveler clockwise or
counterclockwise,
respectively.
I. The two mirror support brackets (#3)
are already attached behind the
dresser (#2). Position the mirror
support brackets (#3) vertically to
align with the pre-drilled holes of the
dresser (#2) AND the mirror (#1).
II. Prepare 6 bolt assemblies by
inserting the flat washer (#B) onto
the bolt (#A). (The other 2 bolt
assemblies are already attached
from the factory.)
III. Insert those bolt assemblies onto the
mirror support brackets (#3) and
secure those bolts using an Allen
wrench (#C) to lock the mirror
support brackets (#3) with the
dresser (#2) AND the mirror (#1).
IV. Tighten all bolts, including those that
were already attached from the
factory.
Back Side
Back Side
#A x 8 pcs
#B x 8 pcs
ASSEMBLY IS COMPLETED