Turn right (clockwise) to tighten
OPTIONAL WALL MOUNT
Page 5 of 5
#B x 4 pcs
#C x 8 pcs
#D x 8 pcs
#E x 4 pcs
ASSEMBLY IS COMPLETED
This is an optional step to assemble the headboard onto the bed
frame (sold separately). Align the holes of the completed
headboard with the holes of the bed frame. Insert the bolts and
washers according to diagram below. Use the supplied tools to
secure those parts.
I.
Wall Mount (No Stud): Select a location where
you want to the headboard to be mounted. Mark
on the wall the two locations where the wall
anchors (#H) will be placed. Drill a hole for each
anchor slightly smaller then the size of the screw.
Push the anchor (#H) as far as it will go with your
finger. Tap gently with a hammer until the wall
anchor (#H) is flush with the wall surface. Align
the headboard (#1) with the anchors (#H). Insert
the screws (#I) with the flat washers (#J) into the
legs (#2) and tighten those screws using a
Phillips screwdriver to lock them down with the
anchors (#H).
II.
Wall Mount to Stud: Repeat the process above
using only the screws (#I) and flat washers (#J)
but WITHOUT the anchors (#H).
Summary of Contents for CM7008HB-T
Page 2: ...Page 2 of 5...
