Page 5 of 5
Turn right (clockwise) to tighten
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
I.
Align the seat frame (#2) with the
pre-drilled holes of the backrest
(#1) and the right and left armrest
(#3 & #4).
II.
Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#C) onto the bolt (#A) and then the
flat washer (#B) onto the SAME
bolt (#A), in that order.
III.
Insert the 2 bolt assemblies
through the seat frame (#2) using
the Allen wrench (#D) to lock them
in with the backrest (#1).
IV.
Insert two bolt assemblies, one
through each side of the seat frame
(#2) using the Allen wrench (#D) to
lock them in with the right and left
armrest (#3 & #4).
Enlarged
ASSEMBLY IS COMPLETED
I.
Carefully place the chair on its back and on a protected surface.
II.
Align the threaded end of the front leg (#5) with the pre-drilled holes on the
bottom of the seat frame (#2) and tighten by hand until secured.
III.
Insert the left and right rear legs (#6 & #7) into the pre-drilled holes on the
bottom of the seat frame (#2).
IV.
Insert 4 screws (#E), two screws for each left and right rear leg (#6 & #7)
and secure those screws using the Phillips screwdriver to lock them in with
the seat frame (#2).
Summary of Contents for CM-AC6802
Page 2: ...Page 2 of 5 ...
