Step 3
Carefully turn the completed unit upright. Make sure the unit
is rested on a flat surface and it does not feel loose or
wobbly. If it does, double check that the bolts are secured
and properly tighten.
Step 4
I.
Insert the screw (#E) near the end of the
the wall strap (#F) and tighten that screw
using a Phillips screwdriver to secure it
with the right stand (#2). Repeat the
process for the other side.
II.
Select a location where you want to the
unit to be displayed. Mark on the wall the
two locations where the wall anchors (#C)
will be placed. Drill a hole for each anchor
slightly smaller then the size of the screw.
Push the wall anchor (#C) as far as it will
go with your finger. Tap gently with a
hammer until the wall anchor (#C) is flush
with the wall surface.
III. Insert the wall screw (#D) through the
other end of the wall strap (#F) and tighten
that screw using a Phillips screwdriver
into the wall anchor. Repeat the process
for the other side.
Turn right (clockwise) to tighten
Page 5 of 5
ASSEMBLY IS COMPLETED
SECURING THE DISPLAY TO THE WALL
#C x 2 pcs
#D x 2 pcs
#E x 2 pcs
#F x 2 pcs
#2
#1
Summary of Contents for CM-AC293
Page 2: ...Page 2 of 5 ...
