Connect handset cable to control box. Align front of handset with
surface edge and secure with 3 wood screws.
22 | SECURE HANDSET AND CONNECT
23 | POWER UP AND INITIALIZE
Connect cord to power source then press and hold
and
simultaneously for 5 seconds until both leg columns are in lowest
position. Desk will slightly rise, lower again, and then stop. Release
buttons. The system is now operational.
24 | ALIGN AND CONNECT WORKSTATIONS
Pass jumper through bridge extension then insert the extension
into the open slot of power bridge on first workstation. Align
second workstation, connect jumper and push workstations
together. Both ends of bridge extension should sit inside of power
bridge.
Use BPROBRG2 (12.25") extension for workstation have 72" surfaces.
Use BPROBRG1 (7.5") extension for workstation 48"-66".
Note: Repeat for all side-by-side workstations.
Note: Width between workstations will vary depending on layout.
S
PRO
U
T
PRO
S
PRO
U
T
PRO
S
ID
E
-
B
Y
-S
ID
E
L
-S
H
A
P
E
S
ID
E
-
B
Y
-S
ID
E
L
-S
H
A
P
E
26
27
