Furmanac Ottoman bed Assembly Instructions Manual Download Page 11

Upholstery Care Guide

This guarantee does not cover the general wear and tear of fabrics. Any claims for upholstery faults 

outside the realms of general wear and tear. Please ensure the following guidelines have been adhered 

to as failure to do so will invalidate your guarantee.

Major cleaning of fabric must be conducted by an upholstery specialist

A multitude of fabrics consisting of different materials, fibres and constructions make up the Furmanac 

swatches. As a result of this it is difficult to provide generalised cleaning instructions, therefore it is 

recommended that any major cleaning is conducted by an upholstery specialist.

Minor stains

Some stains can be removed by means of a damp (not over wet) cloth and soapy water or mild 

detergent if necessary. It is recommended that any chemicals are pretested in an inconspicuous area of 

the product. After cleaning the test area please check the compatibility of the fabrics used, specifically 

monitoring if any colours have faded or any shrinkage has occurred. If a ring remains around the stain 

after cleaning, you’ll need to deep clean the entire product. For more stubborn stains, please consult a 

professional cleaning company.

Third Party Treatments

Furmanac will not accept liability for upholstery problems caused by any third parties when applying 

fabric protection. 

Fabric Fading

To reduce fabric fading avoid letting direct sunlight on product by using blinds or curtains.

Spillages

In the event of a spillage the surface must first be blotted dry with an absorbent colour fast cloth or plain 

kitchen roll. Avoid using coloured towels or printed paper towels as they may transfer dye or ink to the  

upholstery.

• DO NOT apply excessive pressure / rub the spillage as this could permanently damage the fabric.

• If a large amount is spilled, remove as much as possible with clean towelling, a scraper or spoon; blot

up the rest, then treat any remaining stains in the same manner as a minor clean.

• Please note fabrics with a high cotton content are at risk of becoming lighter after spot cleaning.

Pile Crush

All pile fabrics, including Chenilles, are subject to a certain degree of shading or ‘pile crush’. This is not a 

fabric fault, but the effect of ‘pile crush’ can be minimised (not eliminated) by using a soft brush to lightly 

brush the pile in a different direction over areas that show signs of wear.

Additional Warning

ENTRAPMENT

DANGER

ENTRAPMENT

DANGER

Danger – Risk of Injury / Crushing

The ottoman must only be operated by responsible and capable adults. 

 

Never allow children to operate the ottoman.  The mattress must be in place  

before attempting to close your bed.

1

1

VERSION 10

Correct at time of publication 17/03/22

Summary of Contents for Ottoman bed












Reviews: