Furious FPV Radiance DSHOT, User Manual

Page: 23 / 26

22
How to turn on bind mode
NOTE: Plug battery to the quad during setup.
Connect quadcopter to the computer and go to Command-line interface (CLI) tab.
Remember to type “ save ” and hit enter after these commands have been executed.
Type in the commands as pictured above, or copy and paste them from below:
set spektrum_sat_bind=9
set spektrum_sat_bind_autorst=0
save
NOTE – if you are using a DSM2 receiver , change “ set spektrum_sat_bind=9 ” to
“ set spektrum_sat_bind=5 ”
Reboot your Flight Controller by unplugging the Flight Controller from your PC then plugging
it back in.
Your RX should go into bind mode by now as the LED on the RX will be blinking rapidly.