Qu.
Description
Art.-ID
6
Plastic poles, 2 with a removable section 111414
6
Plastic connector parts
111401
2
Plastic post top parts
111402
2
Plastic base foot parts
111403
2
Elastic net centring cords
111419
4
Sand anchors
111408
4
Tension straps, 2-piece
111407
1
Fun net, 8.5m/9.5m
111324/111322
4
Black hooks
111413
1
Beach Bag
111332
Setup Manual
Hints
•
Wipe the sand off the posts before storing them.
• Store all anchors in one single pole section so they cannot
drop out inside the bag.
Recommendation
We recommend the Beach Masters courtline as suitable for this
portable Beachvolleyball set. It consists of 25mm blue strapping
with easticised corner ropes and plastic peg anchors.
Each post is assembled from three pieces. The section
with the FUNTEC sticker is the middle piece. The bottom
section consists of a larger and smaller section. You can
remove the short section of the post if required to reduce the
net height to the recommended ladies height.
Assemble the two parts of the yellow straps as shown.
Make sure the loops are positioned at the ends of the belt
and not near the metal clip lock. Place the small loops of the
straps under the disks on the top of the four sand anchors.
Use two anchors per post. Make sure to knock the anchors
into the ground at a slight angle away from the posts to aid
tensioning.
Put the loops on the other end of the straps over the top
end of the posts and put the posts up sloping inwards. Then
position the cable loops attached to the top ends of the net
over the top of the posts as well.
Elastic net centring: Connect the black elasticised cords
at the top of the post with the red net cords at the top corners
of the net ensuring they are under slight tension. The tension
of the bungees will keep the net centred between the poles
later.
Tighten the yellow straps and adjust the position of the
post as necessery to get the posts upright. The net should
now align midway between the poles automatically but if not
simply adjust the short red ropes at the top of the net to get
it central. Adjust the lower ropes to length at the black hook
end and attach them to the metal clip locks on the yellow
tension straps.
Parts list:
Order spare parts: [email protected]
To obtain the ideal position for the sand anchors, unfold
the net completely 1 . The loops at the ends of the top cable
mark the places for the posts 2 . Drive the anchors into the
ground at a distance of approx. 3.3m from the post position
to form an angle of approx. 45deg with the post 3 . Please
refer to figure 8 at the bottom of this page to get an overview
of the correct placement of posts and anchors.
The net tension and net height can be altered to achieve
the perfect net by adjusting the tension of the ropes at the
bottom corners of the net.
