WWW.FUNNMTB.COM
STRYGE STEM 2022.09.01 / REV. 0
INSTALLATION AND USE
Thank you for purchasing the FUNN STRYGE STEM.
Please read these instructions thoroughly before attempting to install this item.
Following all fitting instructions in order is required for compliance with FUNN’s warranty policy.
STRYGE STEM
2 to 3mm gap from
top of stem
to top of steerer tube.
Remove all bolts. Grease the threads and under the heads.
Ensure the external surface of the steerer tube is both
clean and dry.
Slide the stem onto the steerer, depending
on the rise or drop required.
1.
2.
Fit the top cap and tighten the headset pre-load bolt to
remove any play while keeping the steering smoothly.
3.
．
Torque wrench
．
Stryge stem
1 PC
contents
Steerer tube preparation
stem installation
．
Stryge stem requires a 28.6mm (1 1/8”) steerer tube.
．
Ensure the steerer tube is the correct length – there should be 2-3mm gap from the top of the spacer or stem
to the top of the steerer tube. If the steerer tube requires modifying to fit, ensure it is cut level.
．
Hex key 4mm
tools required
