Funktel f.airnet D5 Series, Operating Manual, Page: 25 / 160

25
D5 / FC5 Series Starting up
login data of a D3, FC1, FC4 or IH4 D11/FC11 type of device, take note of
Section "Information regarding the use of MEM cards In handsets of the
D3, FC1, FC4, IH4 or FC11 type" on page 25 below.
 The handset is then ready to operate.
If your business handset has already been completely assembled
If you receive your D5 or FC5 handset in a fully assembled condition and have
logged in to your telephone system, then you only need to set up and connect
your charger.
Information regarding the use of MEM cards
In handsets of the D3, FC1, FC4, IH4 or FC11 type
All handsets of the D3, FC1, FC4, IH4 or FC11 type require a MEM card for
login (enrolment) on a compatible telecommunication system, similar to the
SIM card of a mobile telephone.
Note: D4 and D11 device versions can, like the D5 and FC5, be operated
without a MEM card. As an option, the devices also enable MEM card to be
used when operating.
After a handset has been logged in by the administrator of the telephone sys-
tem, the respective MEM card contains:
 all the data for login required to operate on this telecom system.
 as a rule, an empty phone book , which can be furnished with phone book
entries by means of either a special configuration tool or individually by
manual input on the handset
Should you wish to use a device of the D5 or FC5 Series as a replace-
ment for a D3, FC1, D4, FC4, IH4 or D11/FC11 that has already logged in
with a MEM card, proceed as follows ...
Inserting a MEM card ...
 Switch the D5 or FC5 off immediately and remove the battery.
 Slide the MEM card into the MEM card slot with the appropriate side