15
• The rib remaining between the two cuts is
removed with the chisel (11) supplied
(fig. 14).
• Deep chases in hard material (e.g.
concrete) can not be cut in a single pass.
• After finishing the working procedure,
swivel the diamond discs (10) out of the
slot with the machine still running.
• Do not brake coasting diamond discs by
applying sideway pressure.
•
Curved cuts are not possible, as the diamond discs could jam in the material.
OPERATION (cont.)
Working advice
WARNING!
Clamp the workpiece if it does not remain stationary due to
its own weight.
• Place the wall chaser (with motor running)
with the chaser roller (1) onto the surface
the chase is to be cut into and slowly
push down until the preset depth of cut is
reached (fig. 11).
• Guide the machine with both handles,
applying moderate feed, suited to the
material being worked.
• Always push the wall chaser in the direction
of cut, e.g. from bottom to top (fig. 12) or
with horizontal cuts, away from operator (fig. 13).
WARNING!
Diamond discs (10) become very hot during operation; do not touch
them until they have cooled down.
1
2
3
Fig. 11
Rib
Fig. 14
1
2
3
Fig. 13
1
2
3
Fig. 12
