10
Fig. 6
STORAGE
Fig. 5
• Before storing your air mover, the power cord & plug (3) should be wrapped around the
carry handle (2) (Fig .5).
• The air mover can be stacked at most 3 units
together (Fig. 6).
•
When not in use, unplug and store the air mover in
a dry indoor place out the reach of children.
MAINTENANCE
• Keep the air intakes (5) of the air mover clean at all times.
• To keep the air mover clean, the outer housing (4) may be cleaned with a soft, damp cloth.
A mild detergent can be used if necessary.
• After cleaning, dry the unit with a soft cloth.
• Wait until the unit is completely dry before use.
WARNING!
Ensure the tool has been switched off and disconnected from the
power supply performing any maintenance or cleaning.
Carbon brushes
When the carbon brushes wear out, the air mover will spark and/
or stop. Discontinue use as soon as this happens. They should be
replaced prior to recommencing use of the air mover. Carbon brushes
are a wearing component of the air mover, therefore not covered
under warranty. Continuing to use the air mover when the carbon
brushes need to be replaced may cause permanent damage to the
tool. Carbon brushes will wear out after many uses but when the carbon brushes need to
be replaced, take the air mover to an electrician or a power tool repairer for a quick and low
cost replacement. Always replace both carbon brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by the
repair of the air mover by an unauthorised person or by mishandling of the air mover.