background image


      Output Wattage: 40W Max.

      Universal Voltage: 120-277V  , 50/60Hz

~

      Output Current: 250-1400mA

 

    

Output voltage range of 11-55V

General Specifications

Input  Voltage 
Input  Current 
Input Power

Standby Input Power 

Output Current
Output Voltage Range
Output Power

Number of Output Channels

RFI/EMI  
Output Type

Ambient Operating Temperature Range

Input Surge Protection

Protections

120-277VAC, 50/60Hz 

0.43A  @ 120VAC 
54W

<0.85W
Constant Current 

11-28VDC ( 250-1400mA ) , 11-40VDC ( 250-1000mA ) , 11-55VDC ( 250-730mA )
40W Max. ( Figure 1 )

1 Channel

FCC Part 15A Non-Consumer
LED Class 2

Line-Neutral 3kV , Line & Neutral-Gound 6kV , Ring Wave ANSI/IEEEC62.41
Input Current Protection
Output Open Circuit Protection 

Output Short Circuit Protection

Output To Ground Short Circuit Protection

250-1400mA [ TPSB 100 ( Program Box ) , Figure 1 ] ; Record New Setting On 1"x0.5" Label

This Driver Will Operate The Following LED Modules: Any LED module designed to accept input voltage range of 11-55VDC and can operate 
up to current of 250-1400mA.

Battery Type

LiFePO4 6.4VDC (Part# FHSBATL2-3.2L)

Battery Capacity Available  

Max. Case Temperature

3200mAh

Battery Recharge Time

12 Hours

Page 1 of 7

Driver Type

FHSAC1-UNV-40C

SPECIFICATIONS

2017-736-1 Rev A

Power Factor

>0.9
<20%

THD

5W or 10W  Initial @ Emergency Mode 

Sound Rating

A

Over Temperature Protection 

Overload Protection 

Dimming Controller Type / Dimming Range

0-10V / 100% - 1%,0% ( Figure 2 ) / Custom Dimming Curve / Dimmed To Off

Service Life

Approvals / Class 

50,000 hours
RoHS , cURus , CEC , Dry or Damp Locations 

MECHANICAL DATA

100%-1%,0%

LiFePO4

E313578

 0°C to 48°C(32°F to 118.4°F) 

63°C(145.4°F)

 

    

Compact case with side leads

MECHANICAL DATA

Case Tolerance=±0.02" 

FHSAC1-UNV-40C

FHSBATL2-3.2L

LED Driver with integrated emergency backup

( Min. 180 Minutes Runtime @ 5W Setting , Min. 90Minutes Runtime @ 10W Setting )

Fulham extends a limited warranty to the original purchaser or first user for a period of 5 years from the date of manufacture when properly installed 
and operated under normal conditions of use. For complete terms and conditions, please refer to the Warranty Center at www.fulham.com. 
Specifications subject to change without notice.

Summary of Contents for FHSAC1-UNV-40C








Reviews: