6
Installation Manual
Models MWOR530A2ASS, MWOR530A3ASS
ENGLISH
7. PREPARATION OF THE OVEN
Turn oven on the side. See Figure 5.
1.
Follow steps (A)-(D) to remove mounting plate
2.
from the back of the oven as shown in Figure 5.
(A) Release mounting plate by pulling out the
lever that is on the bottom of the oven. See
Figure 6.
(B) When lever is out, pull that side of the mount-
ing plate away from the oven. See Figure 5.
(C) Repeat step (A) on other side.
(D) Repeat step (B) on other side.
Figure 5
(A)
(B)
(C)
(D)
Figure 6
Use
screwdriver
to assist in
releasing
mounting plate.
Mounting
Plate
Bottom of
Microwave
(A)
8. VENTILATION SYSTEM
(PREPARING OVEN FOR INSTALLATION)
This Microwave Oven is designed for adaptation to
three types of hood ventilation systems. Select the type
required for your installation.
RECIRCULATING
— non-vented, ductless.
Follow installation procedure (A). Recirculating requires
the use of the Charcoal Filter, which has already been
installed in the oven.
HORIzONTAL EXHAUST
— outside ventilation.
Follow installation procedure (B).
VERTICAL EXHAUST
— outside ventilation.
Follow installation procedure (C).
(A) RECIRCULATING:
NON-VENTED, DUCTLESS OPERATION
The unit is shipped assembled for recirculating. The
1.
Exhaust Damper Assembly
8
is not required for
recirculating operation.
The Charcoal Filter should be replaced every 6 to
2.
12 months, depending on use.
(B) HORIzONTAL EXHAUST:
OUTSIDE VENTILATION
Remove 2 screws from back edge and 3 screws
1.
from the top center of Fan Cover Bracket. Save
2 screws to be used later and discard remaining
3. Remove Fan Cover Bracket by sliding it in the
opposite direction of the arrow on the Fan Cover
Bracket, as shown in Figure 7.
Lift Hood Fan Unit carefully and slip wires out of
2.
cavity. See Figure 8.
CAUTION: Do not pull or stretch hood fan
wiring.
Figure 7
Figure 8
Rotate the Hood Fan Unit 180˚ so that the fan
3.
blade openings are facing the back of the oven.
See Figure 9 (A). Replace Hood Fan Unit into the
oven. Be careful not to pinch the wire and the Hood
Fan Unit. See Figure 9 (B).
Put the wire back into the cavity. See Figure 10.
4.
Figure 9
Figure 10
(A)
Rotate 180˚
(B)
Save fan cover
bracket for future
instructions.