Connect to the power supply
•
Prior to connection, it is recommended to set the temperature control knob to an “OFF” or other
position that disconnects the appliance from the power supply (See page with the control description).
•
This appliance should be connected to AC 220-240V 50Hz supply socket. The socket must be fitted
properly, and must be supplied with an earthing conduit and a 10A fuse.
•
It is a legal requirement that the appliance is properly earthed. The manufacturer will not be held liable
for any damage or injury which may result from the failure to fulfil this requirement.
•
Do not use adapters, multiple sockets and two-wire extension leads. If it is necessary to use the
extension lead, it must be equipped with a protection ring and a single socket and must have a VDE/GS
safety certificate.
•
If an extension lead is used (with a protection ring and safety certificate), its socket must be located at a
safe distance, away from the sinks, and must not be in a place where it could be flooded by water or
waste water.
•
See the type plate at the lower part of the internal wall of the appliance for detailed specifications**.
Disconnect to the power supply
•
Make sure the appliance can be easily disconnected from the mains, either by pulling the plug out of
the mains socket, or by switching the two-pole switch off.
INSTALLATION AND OPERATING CONDITIONS OF THE
APPLIANCE
5