Fulgor Milano FBCD 761 TNF EDBL, User Manual, Page: 10 / 18

EN
8
4.1 Thingsto do for energy saving
ATTENTION
A
Connecting your refrigerator to systems that save
energy is dangerous as they may cause damage on
the product.
• Do not leave the doors of your refrigerator open for a long
time.
• Do not put hot food or drinks in your refrigerator.
• Do not overload the refrigerator. Cooling capacity will fall
when the air circulation in the refrigerator is hindered.
• Do not place the refrigerator in places subject to direct
sunlight. Install the product at least 30 cm away from heat
sources such as hobs, ovens, heater units and stoves and at
least 5 cm away from electrical ovens.
• Pay attention to store your food in refrigerator in closed
containers.
• You can remove the drawer shelf of the freezer compartment
to fill the freezer compartment with maximum amount of food.
The given energy consumption value of the refrigerator has
been determined with the freezer compartment shelf or the
drawer removed and the refrigerator filled with maximum
amount of food. There is no harm in using a shelf or drawer
according to the shapes and sizes of food to be frozen.
• Thawing the frozen foods in the fridge compartment both
saves energy and reserves the quality of the foods
ATTENTION
C
Temperature of the room where your refrigerator is
located should at least be 10ºC/50°F. Operating
your refrigerator under cooler conditions is not
recommended with regard to its efficiency
inside of your refrigerator must be cleaned thoroughly.
If two coolers are to be installed side by side, there
should be at least 4 cm distance between them
4.2 Recommendations About the Fresh
Food Compartment
• Make sure that the food does not touch the temperature
sensor in fresh food compartment. To allow the fresh food
compartment to keep its ideal storage temperature, the
sensor must not be hindered by food.
• Do not place hot foods or beverages inside the product.
4.3 Initial use
Before using the product, make sure that all preparations have
been made in accordance with the instructions given in the
“Important instructions regarding safety and environment” and
“Installation Instruction” chapters.
•
Clean the interior of the refrigerator as recommended in the
“Maintenance and cleaning” section. Before you start the
refrigerator, make sure that the interior is dry.
• Plug the refrigerator in a grounded socket. The interior
illumination is lit when the door of the refrigerator is opened.
• Operate the refrigerator for 6 hours without placing any
food in it and do not open its door unless it is necessary
ATTENTION
C
You will hear a noise when the compressor starts up.
The liquids and gases seled within the refrigeration
system may also give rise to noise, even if the
compressor is not running and this is quite normal.
Front edges of the refrigerator may feel warm.
This is normal.
These areas are designed to be warm to avoid
condensation.
4 Before Using the Refrigerator