Fulgor Milano F6RT24S1, Use & Care Manual

Page: 12 / 60

ENGLISH
Use & Care Manual
12
If a hot surface light is ON use caution when working
around the cooktop as it is still hot.
Once a heating element has been selected, touch the
Q‚*< Z'" = `&
or after setting the power level.
A beep sounds and the heater display shows the
selected power level and a “P” alternatively. The
“Peacock Tail” shows the selected power level.
The heater works at full power (level 9, always on) for
10 minutes. After these 10 minutes the heater returns
to the selected power level.
This option is available for all the cooking zones, both
standard, both special ones (multiple zones or bridge).
*&+
The key lock function is activated or deactivated holding
`Q<>?Z'"|`'
&`'" '<&`Q<>?Z'"
itself is always enabled.
The keys are automatically locked at start-up.
The locking function can be activated regardless of the
heaters condition (working or not). The key lock function
'`'" `Q<Z‚`
Q<+=<Z'"`
"!
It works as a minute minder and it doesn’t stop any
heating element.
The timer is available in some models only. It can be set
independently from the heating element, even if there
aren’t any working zones. If the cooktop is not working,
` { ` Q<+=<Z '" X "
mode, with all displays showing “0”.
1
2
3
Figure. 10
`QXZQ[Z'"`Œ`
starts from “00” or “45” respectively on the timer display
(ref.1). Hold the key in order to fasten the increase/
decrease speed. The maximum value is “99”.
The timer led (ref.2) indicates whether the timer is
running.
The dot in the lower right corner of the display (ref.3) is
}````
change its value. After 5 seconds since the last touch
the new value is accepted and the dot disappears.
‚ { ` `
correctly.
`&`QXZ'"`
‰‹‹Š ` ` QXZ Q[Z "
order to reset the value to “00” rapidly.
In some models the timer can be set in relation with a
cooking zone:
^ `'#"
^ ` QXZ Q[Z& ` ` #
}`
^ `
^ `"&`
the countdown begins.
If more than one timer is set, the display shows the
&``ˆ{`
(ref.4) related to the zone which the displayed value is
&}` `"
`&`|}`
4
Figure. 11
To check the remaining time for any one of the timed
#& ` ` Q<+Z '" ` #Π`
}``
on the timer display will switch for some seconds to the
new value. After a time-out, it will switch back to the
shortest one.
To check the independent timer value when it’s not
"````"&`QXZQ[Z`
#`@}`
the displayed value switches to the independent timer.