FRE-301R
INSTRUCTIONS
Supplied by
Laser Levels Online
– The Laser Level Specialists
www.laser-level.co.uk
Tel: 08000 869 769
Thank you for purchasing the Fukuda
FRE-301R
RED
beam, rotary laser kit.
These instructions are intended to explain the
quick basics
to operating this
equipment. Please read them carefully.
For any more information, or if the laser requires calibration or repair; then
please contact our Service Department on Tel. 01246 260 007.
Email: [email protected] We are here to help.
Power source:
This is a special battery pack located in the base of the laser. Remove & refit
via a central screw - finger tight (no tools are required).
It contains 4pc x "sealed for life" Ni-MH type C, 4000mAh, 1.2V cells. Please
note that this battery pack can be charged either in or outside of the laser.
The Mains Charger (supplied) will charge most batteries in around 7 hours to
give around 40 hrs of continuous use. It takes 4 to 5 charge/discharge cycles
for these battery packs to reach their maximum capacity.
Important:
Do NOT allow battery to go completely dead before recharging.
1
