Fujitsu XG2000R, Hardware Manual

Page: 46 / 75

44
Installation
The following explains the names and functions of the components at the front of the
XG2000R.
• Ports 1-20 These ports comply with the XFP MSA Standards. The con-
nection method varies depending on which XFP modules are
installed.
• Link/Act LEDs (Green) Displays the condition of the respective port.
Each LED lights when a link is established on its port.
The link is established a few seconds after the received signal
is detected.
Blinks when the XG2000R sends and receives the traffic.
• Dump Switch Used to collect maintenance information.
• Mng-LAN Used when performing maintenance or adjusting the settings
(LAN connection).
- Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
- Mng - LAN Link/Act LED (Green) Lights when the link is established.
Blinks during the XG2000R sends and receives
the Frame.
• Serial Port Used when performing maintenance or adjusting the settings
(Console connection).
• Status LED (Green) Lights when the XG2000R is in an operable state.
• Alarm LED (Orange) Lights when there is a problem with the XG2000R.
• Power LED (Green) Lights when the XG2000R is receiving power.
1-2
XG2000R Components
This section explains the names and functions of the various XG2000R components, including the
various indicator LEDs.
XG2000R front
Alarm LED (Alarm)
Power LED (Power)
Status LED (Status)
XFP/Port 1 - 20
upper stand : odd number
lower stand : even number
Mng-LAN
Mng-LAN Speed LED
Mng-LAN Link/Act LED
Serial Port
Link/Act LED
Link/Act LED
Dump Switch