Service Tips
Setting up the Thermo Sensor on the UTY-RNNUM
Disclaimer:
In order to perform some of these tests an electrical and/or refrigerant license is required. We strongly advise to check the Service manual for more detailed explanation. If you are not sure about these recommendations please contact us at 866-952-8324.
© 2017 Fujitsu General America, Inc.
# 005
1/13/17
by
1) With the wired remote off, press both
the Set Temp Up & Down buttons
along with the Fan Control button
simultaneously for 5 seconds or more
to enter the function setting mode.
2) The remote should display
00:00
on
the timer.
3) Press the right Set Time buttons to
select the function number. The
function numbers will be
00:42
and
00:48
. You will need to set them one
at a time.
4) Press the Set Temperature buttons,
Up and Down, to select the setting
value of
‘01’
.
5) Press the Timer Set button to lock in
the settings. The ‘
01’
will flash.
6) Cut power for the system for one
minute than restore power back to
the system. You can set both
functions,
00:42
and
00:48
than shut
off power.
7) Once power is restored you can
activate the thermo sensor. Press and
hold the Thermo Sensor button to
activate the thermo sensor.
*See attached Engineering Bulletin ‘
How to Enter Function Settings’.
Set Time Left
Set Time Right
Thermo Sensor Icon
Function Number
Setting Value
Thermo Sensor Icon
Fan Control
Set Temp. Down
Set Temp. Up
Page 1 of 2