Fujitsu TeamPoS 2000, Installation And Maintenance Manual, Page: 143 / 234

7.1.2 Powering OFF
1. Lift the plastic switch cover.
2. Press the ON/OFF switch.
7.2 PC Board Replacement
The following instructions apply for both the M & the A motherboards.
1. Remove the front cover (see section 5.1.1).
2. Remove the side cover (left) (see section 5.1.2).
3. Disconnect all peripheral cables connected to the PC board.
4. Locate the lever below the PC board and pull towards you.
90000291 Rev 3.0 7-3
TeamPoS 2000 MAINTENANCE MANUAL
Note: For proper shutdown procedures, see the application software
documentation.
Caution: To prevent electric shock, confirm that the AC cable is removed from
the AC outlet anytime the covers are removed. Be sure to observe all
ESD precautions and power off procedures.
Caution: Be sure to observe all ESD precautions and power OFF
procedures.
When replacing the PC board, ensure AC power cord is
removed/unplugged before any maintenance is performed! The
power unit of this equipment always supplies electric power to
maintain the equipment in standby condition. Therefore, when the
equipment is connected with an AC outlet, a part of the main board
circuit is charged even if the equipment power is OFF.