Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Check whether the Recovery and Utility option is present. If it is not present, it means
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Cursor down to
Recovery and Utility
and press the
Enter
key.
4. Choose your language, if necessary. Select
Recovery and Utility
to proceed.
5. Three tool options appear:
Diagnostics
,
Recovery
, and
Utility
(refer to the Recovery and
Utility tools section below for instructions on how to use these tools).
6. If this was successful please skip the next step and go to “Recovery and Utility tools.”
7. If this was NOT successful, please go to the next step.
Running Recovery and Utility from the Bootable disk
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power on your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootable disk into the drive tray.
3. Highlight the CD/DVD option from the Boot menu, then press
Enter
.
4. Click
OK
.
5. Select CD/DVD boot mode: UEFI Mode, if applicable, and then press
Enter
.
While the
fi
les are being loaded from the disk, the Fujitsu logo screen will appear
followed by a progress bar at the bottom of the screen.
98
Fujitsu
