Fujitsu SPARC M10-4, Service Manual

Page: 312 / 514

XSCF>
showlogs error
XSCF>
replacefru
Note -
In the case of a dual power feed, make a note of the locations of the power cords
before disconnecting them to ensure that they are reinstalled correctly.
Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.5 Notes
Regarding Static Electricity ."
For details, see " 3.3.5 Checking log information ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Stop the entire system.
For details, see " 5.4 Stopping the Entire System ."
6.
Execute the replacefru command to release the chassis requiring maintenance
from the system.
For a single-chassis configuration, you do not have to release the chassis.
Proceed to step 7.
For details, see " 5.1.1 Releasing an FRU of the SPARC M10-4/M10-4S from the
system ."
7.
Remove all the power cords from the PSU backplane unit of the chassis
requiring maintenance.
For details, see " 5.5.2 Removing the power cord ."
15.4 Removing the Operation Panel
This section describes the procedure for removing the operation panel.
Enable the removal of the operation panel before attempting to remove it. For details,
see " 15.3 Enabling the Removal of the Operation Panel ."
15.4.1 Accessing the operation panel
1.
Check the BB-ID switch on the operation panel and record the BB-ID set for
the chassis requiring maintenance.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 288