Fujitsu SPARC M10-4, Service Manual

Page: 294 / 514

Note - See the procedure for system-stopped maintenance for inactive/cold maintenance in a
single-chassis configuration.
Caution -
To completely shut down the system, all the power cords must be
removed. If the power cords are not removed, an electrical failure may occur.
Note - Use the DR of the system board on a physical partition for active/cold maintenance.
For the XCP and Oracle VM Server for SPARC/SRU versions that correspond to the DR, see
the latest Product Notes .
Note - Active/cold maintenance can be performed only for a building block configuration.
XSCF>
showlogs error
XSCF> replacefru
■
Active/Cold maintenance
■
Inactive/Cold maintenance
■
System-stopped maintenance
14.3.1 Active/Cold maintenance
1.
Open the rack door.
2.
Log in to the XSCF shell.
3.
Execute the showlogs command to identify the component requiring
maintenance.
For details, see " 3.3.5 Checking log information ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Release the chassis in which the PSU backplane unit requiring maintenance
is mounted, from the physical partition.
For details, see " 5.2 Releasing a Chassis from the Physical Partition ."
6.
Execute the replacefru command to release the chassis requiring maintenance
from the system.
For details, see " 5.1.1 Releasing an FRU of the SPARC M10-4/M10-4S from the
system ."
7.
Remove all the power cords from the PSU backplane unit of the chassis
requiring maintenance.
For details, see " 5.5.2 Removing the power cord ."
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 270