Fujitsu SPARC M10-4, Service Manual

Page: 278 / 514

#
ldm stop iodomain
#
ldm remove-io /BB1/PCI0 iodomain
Note - Inactive/hot maintenance can be performed only for a building block configuration.
For a single-chassis configuration, system-stopped maintenance should be performed.
e.
Release from the physical partition the chassis in which the PCIe card
requiring maintenance is mounted.
For details, see " 5.2 Releasing a Chassis from the Physical Partition ."
13.4.3 Inactive/Hot maintenance
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
3.
Power off the physical partition requiring maintenance.
For details, see " 5.3 Powering Off the Physical Partition Requiring Maintenance ."
13.4.4 System-stopped maintenance
The PCIe cards can be removed/installed while the input power to the chassis is on
(power cord is connected).
This section explains how to perform all types of maintenance work while the power
cord of the chassis remains connected.
1.
Open the rack door.
2.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
3.
Stop the entire system.
For details, see " 5.4 Stopping the Entire System ."
13.5 Removing a PCI Express Card
This section describes the procedure for removing a PCIe card. Perform reduction
using the same procedure.
For installation, remove the filler for a PCIe card instead of removing a PCIe card.
Enable the removal of the PCIe card before attempting to remove it. For details, see
" 13.4 Enabling the Removal of a PCI Express Card ."
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 254