Fujitsu SPARC M10-1, Service Manual

Page: 30 / 230

(1) (2)
Location
number Component
1 Mo de switch
2 POWER switch
Table 2-1 Functions of the mode switch
Icon Name Description
Locked mode Mode used for normal operation
- The power switch can be used to start the system but cannot be
used to stop it.
Service mode Mode used for maintenance
- The power switch cannot be used to start the system but can be
used to stop it.
- Place the system in Service mode to perform maintenance
work with the system stopped.
Table 2-2
Functions of the power switch
Icon Operation Description
Brief press
(For 1 second or
more and less than 4
seconds)
If the system has been
started in Service mode:
Operation is ignored.
If the system is stopped in
Service mode:
Operation is ignored.
Figure 2-7
Operation panel switches
The mode switch sets the operation mode for the system. The Locked and Service
operation modes can be switched by sliding the mode switch.
Table 2-1 describes the difference between the modes.
Use the power switch to start or stop the system. The system starts/stops differently
depending on how the power switch is pressed.
Table 2-2 describes how system starts/stops vary depending on how the power
switch is pressed.
Fujitsu M10-1/SPARC M10-1 Service Manual
･
November 2014 14