Fujitsu SPARC Enterprise T5140, Installation Manual, Page: 82 / 130

60 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
Related Information
■
“Booting the Solaris Operating System” on page 60
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide
Booting the Solaris Operating System
The Solaris OS is preinstalled on the servers on the disk in slot 0. The Solaris OS is
not configured (that is, the
sys-unconfig
command was run in the factory). If you
boot the system from this disk, you will be prompted to configure the Solaris OS for
your environment.
Related Information
■
“To Boot the Solaris Operating System” on page 60
■
“To Avoid Booting the Solaris Operating System at Startup” on page 61
■
SPARC Enterprise T5140 and T5240 Servers Administration Guide
▼
To Boot the Solaris Operating System
1. At the
ok
prompt, boot from the disk that contains the Solaris OS.
/SYS/MB/USB
number USB ports (0-1, located on rear
of chassis)
/SYS/MB/CMP
n
/L2_BANK
number CMP (0-1) Bank (0-7)
/SYS/DVD
DVD
/SYS/USBBD/USB
number USB ports (2-3, located on front
of chassis)
/SYS/TTYA
DB9 Serial Port
/SYS/MB/CMPn/MRn/BR/
branch_number
/CH
channel_number /D dimm_number CMP (0-1) Riser (0-1) Branch
(0-1) Channel (0-1) DIMM (0-3)
TABLE:
Device Identifiers and Devices (Continued) (Continued)
Device Identifiers (Continued) Devices (Continued)