Fujitsu SPARC Enterprise T5140, Installation Manual, Page: 72 / 130

50 SPARC Enterprise T5140 and T5240 Servers Installation Guide • July 2009
If your network does not use DHCP, the network management port is not operational
until you configure network settings for the service processor. Configure the service
processor in this order:
1. After the service processor boots, access the ILOM CLI through the serial
management port. See “To Log Into the Service Processor Using the Serial
Management Port” on page 51 .
2. Configure the service processor. See “To Configure the Service Processor Network
Management Port” on page 52 .
3. Commit the changes to the service processor parameters. See Step 3 in “To
Configure the Service Processor Network Management Port” on page 52 .
You can now use the network management port at any time to access the service
processor.
Related Information
■
“Logging Into the Service Processor” on page 50
Logging Into the Service Processor
If you are powering on the system for the first time after installation, use the service
processor serial port to power on the system and run POST. See
“To Log Into the
Service Processor Using the Serial Management Port” on page 51 .
If the network management port has already been configured, you can use it instead
of the serial management port.
Related Information
■
“To Log Into the Service Processor Using the Serial Management Port” on page 51
■
“To Log Into the Service Processor Using the Network Management Port” on
page 55
Commands:
cd
set
show