Fujitsu SPARC Enterprise T2000, Service Manual, Page: 70 / 174

3-30 SPARC Enterprise T2000 Server Service Manual • April 2007
TABLE 3-10
shows typical combinations of ALOM CMT variables and associated
POST modes.
3.4.2 Changing POST Parameters
1. Access the ALOM CMT
sc>
prompt:
At the console, issue the
#.
key sequence:
2. Use the ALOM CMT
sc>
prompt to change the POST parameters.
Refer to
TABLE 3-9
for a list of ALOM CMT POST parameters and their values.
The
setkeyswitch
parameter sets the virtual keyswitch, so it does not use the
setsc
command. For example, to change the POST parameters using the
setkeyswitch
command, enter the following:
TABLE 3-10
ALOM CMT Parameters and POST Modes
Parameter
Normal Diagnostic Mode
(Default Settings)
No POST Execution
Diagnostic Service
Mode
Keyswitch
Diagnostic Preset
Values
diag_mode normal
off
service normal
setkeyswitch
*
* The
setkeyswitch
parameter, when set to
diag
, overrides all the other ALOM CMT POST variables.
normal normal normal diag
diag_level
\
\ Earlier versions of firmware have
max
as the default setting for the POST
diag_level
variable. To set the default to
min
, use the
ALOM CMT command,
setsc diag_level min
min
n/a
max max
diag_trigger power-on-reset
error-reset
none
all-resets all-resets
diag_verbosity normal
n/a
max max
Description of POST
execution This is the default POST
configuration. This
configuration tests the
system thoroughly, and
suppresses some of the
detailed POST output. POST does not
run, resulting in
quick system
initialization, but
this is not a
suggested
configuration. POST runs the
full spectrum of
tests with the
maximum output
displayed. POST runs the
full spectrum of
tests with the
maximum output
displayed.
#.
sc> setkeyswitch diag