Fujitsu SPARC Enterprise T2000, Service Manual

Page: 146 / 174

5-40 SPARC Enterprise T2000 Server Service Manual • April 2007
8. Perform the procedures described in Section 5.3, “Common Procedures for
Finishing Up” on page 5-41
5.2.21 Removing the Battery on the System Controller
1. Perform the procedures described in Section 5.1, “Common Procedures for Parts
Replacement” on page 5-1 .
2. Remove the system controller from the chassis ( Section 5.2.5, “Removing the
System Controller Card” on page 5-17 ) and place the system controller on an
antistatic mat.
3. Using a small flat-head screwdriver, carefully pry the battery (
FIGURE 5-27
) from the
system controller.
FIGURE 5-27
Removing the Battery From the System Controller
5.2.22 Replacing the Battery on the System Controller
1. Unpackage the replacement battery.
2. Press the new battery into the system controller (
FIGURE 5-28
) with the positive
side (+) facing upward (away from the card).
FIGURE 5-28
Replacing the Battery in the System Controller
Battery