Fujitsu SPARC Enterprise T2000, Installation Manual, Page: 33 / 88

Chapter 1 Preparing for Installation 7
■
TTYA serial port: Use the DB-9 connector with a null modem cable for serial
devices. This port appears as
ttya
in Solaris OS and OpenBoot messages. This
port is not connected to the SC serial management port.
■
USB Ports: USB ports support hot-plugging. You can connect and disconnect USB
cables and peripheral devices while the system is running, without affecting
system operations.
■
You can only perform USB hot-plug operations while the OS is running. USB
hot-plug operations are not supported when the system
ok
prompt is
displayed or before the system has completed booting.
■
You can connect up to 126 devices to each of the two USB controllers, for a
total of 252 USB devices per system.
■
AC power cables: Do not attach power cables to the power supplies until you
have finished connecting the data cables, and have connected the server to a serial
terminal or a terminal emulator (PC or workstation). The server goes into standby
mode and the ALOM CMT system controller initializes as soon as the AC power
cables are connected to the power source. System messages may be lost after 60
seconds if the server is not connected to a terminal, PC, or workstation.
Slide Rail Assembly Notes
The rackmount kit has two slide rail assemblies . A slide rail assembly can be installed
on either the right or left side of the rack.
Each slide rail assembly consists of a three-section slide rail and a removeable
mounting bracket (
FIGURE 1-4
).