Fujitsu SPARC Enterprise T2000, Installation Manual, Page: 34 / 88

8 SPARC Enterprise T2000 Server Installation Guide • April 2007
FIGURE 1-4
Sections of the Slide Rail Assembly
■
The front , middle , and rear sections form the slide rail . The middle and rear sections
have holes for mounting screws and adjust to fit rack depths from 24 in (61 cm) to
36.5 in (93 cm). The front section can be extended to allow movement of the
server out of the rack.
■
The removeable mounting bracket slides 14 in (36 cm) out of the slide rail, then
locks in place. If you unlock the mounting bracket at this point, it slides an
additional 12 in (30 cm) before separating from the slide rail. You can then mount
the mounting bracket to the right or left side of the SPARC Enterprise T2000
server chassis.
■
Note that there are a total of five locks (
FIGURE 1-5
) in a slide rail assembly. Four
are on the mounting bracket. One lock is on the front section of the slide rail. The
uses of these locks are described in the installation procedure in
Chapter 2 .
Mounting bracket
Rear section
Front section
Middle section