Fujitsu SPARC Enterprise T2000, Installation Manual, Page: 32 / 88

6 SPARC Enterprise T2000 Server Installation Guide • April 2007
FIGURE 1-3
Front Panel USB Ports
Cabling Notes
■
Minimum cable connections for the SPARC Enterprise T2000 server:
■
At least one system on-board Ethernet network connection (NET port)
■
The system controller serial management port (SER MGT port)
■
The system controller network management port (NET MGT port)
■
Power cables for the two system power supplies
■
System controller (SC) management ports: There are two SC management ports
for use with the ALOM CMT system controller.
■
The SC serial management port (labeled SER MGT) uses an RJ-45 cable and is
always available. This is the default connection to the ALOM CMT system
controller.
■
The SC network management port
(labeled NET MGT) is the optional
connection to the ALOM CMT system controller. This port is not available until
you have configured network settings for the system controller (through the SC
serial management port). See
“Enabling the System Controller Network
Management Port” on page 37 . The SC network management port uses an
RJ-45 cable for a 10/100 BASE-T connection. This port does not support
connections to Gigabit networks.
■
See the SPARC Enterprise T2000 Server Overview for more information.
■
Ethernet ports
are labeled NET0, NET1, NET2, and NET3. The Ethernet interfaces
operate at 10 Mbps, 100 Mbps, and 1000 Mbps. The transfer rates for the Ethernet
ports are given in
TABLE 1-1
.
TABLE 1-1
Ethernet Connection Transfer Rates
Connection Type IEEE Terminology Transfer Rate
Ethernet 10BASE-T 10 Mbit/sec
Fast Ethernet 100BASE-TX 100 Mbits/sec
Gigabit Ethernet 1000BASE-T 1000 Mbit/sec
USB Port2
USB Port3