Fujitsu SPARC Enterprise T2000, Installation Manual, Page: 30 / 88

4 SPARC Enterprise T2000 Server Installation Guide • April 2007
6. Connect the data cables to the server, but do not connect the AC power cable yet.
See “Connecting Cables to the Server” on page 25 .
7. Connect the AC power cable to the server and examine the display for any error
messages. See “Powering On the System for the First Time” on page 33 .
Caution – There is a potential for electric shock if the server and related equipment
are not properly grounded.
Note –
The system controller (SC) runs on the 3.3v standby voltage. As soon as AC
power is connected to the system, the system controller immediately powers on,
runs diagnostics, and initializes the ALOM CMT firmware.
8. After the system controller boots, access the ALOM CMT command line interface
through the serial management port. See “To Log Into the System Controller
Using the Serial Management Port” on page 38 .
9. Configure the SC network addresses. See “To Configure the System Controller
Network Management Port” on page 39 .
Note –
The SC network management port is not operational until you configure
network settings for the system controller (through the SC serial management port).
10. Enable the new configuration by resetting the system controller. See “To Reset
the System Controller” on page 42 .
11. Power on the server from a keyboard using the ALOM CMT software. See “To
Power On the System” on page 44 .
12. Configure the Solaris™ OS. See “Booting the Solaris Operating System” on
page 46 .
The Solaris OS is preinstalled on the SPARC Enterprise T2000 server. When you
power on, you are automatically guided through the Solaris OS configuration
procedure.
13. Install any required patch or patches to the server.
Refer to the SPARC Enterprise T2000 Server Product Notes for a list of the required
patches.
14. Load additional software from the Solaris media kit (optional).