Fujitsu SPARC ENTERPRISE T1000, Installation Manual, Page: 44 / 84

18 SPARC Enterprise T1000 Server Installation Guide • April 2007
a. At the rear of the rack, insert the left side of the tool into slots at the end of the
middle section on the left slide rail (
FIGURE 2-7
).
FIGURE 2-7
Using the Slide Rail Spacing Tool to Adjust the Distance Between the Slide
Rails
b. Insert the right side of the tool into slots at the end of the right rail, while
simultaneously sliding the end of the rail to the right or left as needed to allow
the ends of the tool to enter both middle sections.
When the tool is properly inserted, the distance between the rails is 17.4 in. (442
mm).
c. Tighten the screws to lock the ends of the slide rails in place.
d. Remove the slide rail spacing tool.
Front