Assembly Instructions
SMARTCASE S500
__________________________________________________________________________________________________________________________________________________________
Page 6 of 18
www.fujitsu.com
Active Heatsink
Note: The assembly solution with the coloured plastic part as shown above will be replaced
by an alternative “SoC die-crack-protection” implementation in future.
Note:
Recommended mounting torque for heatsink
screws: 0.6Nm (max. 0.8Nm)
Active heatsink positioning:
Heatsink must be positioned according to
picture
Mounting Backplate:
Do
not
remove the insulating foil of the
backplate, otherwise the mainboard may be
damaged
due to possible short circuit
Hold the heatsink with one hand so
that it doesn’t tilt while installing the
screws
Assemble all 4 screws according to the
order shown. Each screw can be
tightened immediately!
Finally, remove the coloured plastic
part by turning it carefully clockwise.
This coloured plastic part is used for
secure assembly of the heatsink in
order not to damage the CPU die (“die
crack protection”).
After assembly, this part can be
scrapped
2
3
4
1
5
