Fujitsu Primergy RX600 S2, User Manual

Page: 248 / 299

248
Chapter 8 Configuring Hardware and Utilities
8.3.9 ASR&R Submenu
Settings for booting control are configured on the [ASR&R] submenu.
table: Items on the ASR&R Submenu
Item Settings Description
O/S Boot Timeout • Enabled
• Disabled
（
initial
value
）
Set whether or not to enable the "OS Boot
Monitoring" function. The system restarts
automatically in case of stopping booting the OS.
This can be set on the ServerView.
Note:
Be sure to set “Disabled“ when the
ServerView is not installed to the OS. If you
set “Enabled” in above case, unintended
power-off or restarting may occur.
Even with the ServerView, when the system is
booted with the ServerStart CD-ROM or DOS
floppy disk, be sure to set “Disabled“. If you
set “Enabled” in above case, unintended
power-off or restarting may occur.
To set this function, refer to “ServerView
User’s Guide“ to understand the
specifications and operational procedures.
O/S Boot WD Time (min)
• 100
（
initial value
）
• 0
～
100
Set the time out value by the minute.
O/S Boot WD Behavior • Continue
（
initial value
）
• Reset
• Power Cycle
Set the behavior in time out.
ASR&R Boot Delay (min)
• 2
（
initial value
）
• 0
～
30
Set the standby time between shutdown and
restarting by the minute. When the standby time
passes, the system is restarted.
Power Cycle Delay
• 5
（
initial value
）
• 0
～
15
Set the time between power off and on.
Boot Retry Counter
• 3
（
initial value
）
• 0
～
7
Set a maximum number of retrying OS booting.
Diagnostic System Disabled
（
unchangeable
）
This value cannot be changed.
Next Boot Uses Boot Option
（
unchangeable
）
This value cannot be changed.
Diagnostic Lan Device Use Boot Order
（
unchangeable
）
This value cannot be changed.
Temperature Monitoring Disabled
（
unchangeable
）
Set whether being possible to turn on the server
outside the range of temperature conditions (10 to 35
degrees C).