Fujitsu Primergy RX600 S2, User Manual

Page: 148 / 299

148
Chapter 5 Operations after OS Installation
5.4 Creating Maintenance Tools
This section explains how to create tools for maintaining the server.
Maintenance tools are created with the FloppyBuilder function of ServerStart.
With the FloppyBuilder function of ServerStart, you can create the following tool:
• DOS floppy disks
The FloppyBuilder can be used under environments such as:
• the ServerStart system started on a client computer (recommended)
• the system started on the server using the ServerStart CD-ROM
When creating the tools on a client computer, it is necessary to install ServerStart on the client
computer beforehand. Install it according to "2.4 Preparation for Using ServerStart on a Client
Computer" ( pg.53).
If ServerStart of a different version is installed in the computer, make sure to uninstall the ServerStart.
Then perform installation again. For details on how to uninstall ServerStart, refer to "2.4.2 Uninstalling
ServerStart" ( pg.56).
The FloppyBuilder function may not operate correctly if you start up ServerStart while ServerStart of a
different version is installed in the computer. Make sure to uninstall a different version of ServerStart.
ServerStart cannot be started up on the server in which Windows Server 2003 x64 is installed. Be sure
to start up ServerStart on the client computer or the server in which Windows 2000 Server or Windows
Server 2003 is installed.
5.4.1 Creating a DOS Floppy Disk
For DOS data stored into the floppy disk, refer to the file in the following folder of the ServerStart CD-
ROM.
[CD-ROM drive] :\FreeDOS
To create a DOS floppy disk, you need an unused floppy disk. Prepare it in advance.
If ServerStart has already been started, it is not necessary to restart it. If it has not, start it up according to
the following procedures: