Fujitsu PRIMERGY RX2540 M6, Upgrade And Maintenance Manual

Page: 529 / 680

▶ Connect all cables to the system board.
For the cable plans, see
"Appendix B" on page 571 .
Concluding steps
▶ If applicable, install the TPM, see "Installing the TPM" on page 481 .
▶ If applicable, install the Dual microSD 64GB Enterprise, see "Installing the
Dual microSD 64GB Enterprise" on page 506 .
▶ If applicable, install all M.2 SSDs, see "Installing the M.2 SSD" on page 498 .
▶ Install the iRMC microSD card, see "Installing the iRMC microSD card" on
page 492 .
Ensure that you install the iRMC microSD card that was installed in
the system board before the replacement.
▶ If applicable, install all expansion cards, see "Installing the expansion card"
on page 256 .
▶ "Installing the cross bar" on page 81 .
▶ "Installing the fan cage" on page 76 .
▶ Install all riser modules, see "Installing a riser module" on page 72 .
▶ For a system with air cooling, proceed as follows:
▶ Install all memory modules, see "Installing a memory module" on
page 338 .
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
CAUTION
In case of Optane PMem modules are not reinstalled in the right
slots, data can be lost!
▶ If applicable, install all dummy memory modules, see "Installing a
memory dummy module" on page 343 .
System board and components
RX2540 M6 Upgrade and Maintenance Manual 529