Fujitsu PRIMERGY RX220, Options Manual, Page: 41 / 61

RX220
Options Guide 41
9 RemoteView Components
V
CAUTION!
Please observe the safety information in the chapter “Safety Instructions”
on page 13 ff.
9.1 Installing the RemoteView Service Board
S2 LP
I
How to install/remove and configure the RSB S2 LP is described in detail
in the manual “RemoteView Service Board S2/S2 LP 1.x, Mounting and
Setting Up”.
The RemoteView Service Board S2 LP (RSB S2 LP) is a PCI board including a
completely independent system, i.e. it has a separate operating system with a
Web server and SNMP agent and can be driven by an external power supply.
The RSB S2 LP should preferably be installed in the low-profile PCI slot, but can
also be installed in the full-height slot.
It is connected to the system board via a data cable and a power cable. The
RSB S2 LP enables remote diagnostics for system analysis, remote system
configuration, and a remote restart if the operating system fails or if a hardware
error occurs.
Ê Open the server as described in the chapter “Preparation” on page 19 f.
Ê Remove the riser card holder (see page 38 ).
Ê
Plug the supplied power cable into the J302 connector on the RSB S2 LP.
Ê
Plug the supplied data cable into the J104 connector on the RSB S2 LP.
Ê Remove the slot cover.
I
Keep the slot cover for future use. If you remove the RSB S2 without
installing a new one, you must reinstall the slot cover to comply with
EMC regulations (regulations on electromagnetic compatibility) and
to satisfy cooling requirements and fire protection measures.
Ê Install the RSB S2 LP in the PCI-X slot of the riser card. The procedure is
described in the
section “Installing controllers” on page 38 .