240
Chapter 9 Operation and Maintenance
9.2.2 Error Messages
This section explains the error messages for this server.
■
POST Error Messages
This section explains error messages of Power On Self Test: a device check performed during the server
startup (POST).
If an error occurs during POST, the following messages are displayed.
table: List of POST Error Messages
Message
Contents
Stuck Key
Remove objects, if any, that are pressing against any keys on the
keyboard. Check to see whether the keyboard is connected
properly. If the message still appears even though the server has
been restarted, replace the keyboard. If the message still appears
after keyboard replacement, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of "Start
Guide".
Keyboard error
Keyboard controller error
Remove objects, if any, that are pressing against any keys on the
keyboard. Check to see whether the keyboard is connected
properly. If the message still appears, replace the keyboard. If
the message still appears after keyboard replacement, the
baseboard must be replaced. Contact an office listed in the
"Contact Information" of "Start Guide".
System RAM Failed at offset: ********h
A memory error has occurred. Turn the server off and check that
the memory modules are installed properly. If the message
appears after the server is turned on, check the system event log
and replace the memory modules. If the message still appears,
the baseboard must be replaced. Contact an office listed in the
"Contact Information" of "Start Guide".
Shadow RAM Failed at offset: ********h
Extended RAM Failed at address line: ****h
Memory type mixing detected.
A memory error has occurred. Check that the correct CPUs are
installed. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of "Start Guide".
Memory decreased in Size
A memory error has occurred. Refer to the system event log and
replace the abnormal DIMM. If the message still appears, the
baseboard must be replaced. Contact an office listed in the
"Contact Information" of "Start Guide".
"7.3 Installing Memory Modules" (pg.181)
Non Fujitsu Siemens Memory Module
detected - Warranty restricted!
A memory error has occurred. This message appears when using
memory module other than Fujitsu products. Check to see that
BIOS Setup Utility settings are correct. If the message still
appears, the baseboard must be replaced. Contact an office listed
in the "Contact Information" of "Start Guide".
"8.1 BIOS Setup Utility" (pg.202)
System battery is dead - Replace and run
SETUP
A battery error has occurred. Contact an office listed in the
"Contact Information" of "Start Guide".
System CMOS checksum bad - Default
configuration used
Correct the current settings with the BIOS Setup Utility or
restore the settings at the time of purchase. If the message still
appears, the baseboard must be replaced. Contact an office listed
in the "Contact Information" of "Start Guide".
