A26361-K863-Z102-8-7619
Rev. 8.0
29
Installing the Hardware
Installing the System Into the Rack
Figure 5: Mounting the carrier rails
Ê
Loosen the four screws for adjusting the rail length and place the guide lug
(a) into the corresponding hole of the support bracket (1).
Ê
Place two plugwashers (see figure 6 on page 29) in the holes of the front left
support upright at the marked attachment points and, while holding the rail
in place, fasten it with two screws (2).
Ê
Place two plugwashers (see figure 6 on page 29) in the holes of the support
bracket at the marked attachment points and, fasten it with two screws (3).
Figure 6: Mounting the plugwashers into the support bracket
Ê
Fasten the four screws for adjusting the rail length.