A26361-K863-Z102-8-7619
Rev. 8.0
101
The Server Blade
Adding/Removing a Server Blade to/from the System
Removing the Server Blade
The server blade is removed in the same way with the dummy module (see
“Removing the Dummy Module” on page 96).
V
CAUTION!
Observe the safety information and the information on handling electro-
static-sensitive components in the section “Components With Electro-
static Sensitive Devices” on page 18.
Server blades can be extremely sensitive to electrostatic discharge and
must always be handled carefully. After removing the server blade from
the system, place it with the component side up on a non-conductive,
antistatic surface. Do not slide the server blade over any surface.
When you remove the server blade and do not replaced it with a new one, you
must insert a dummy module into the empty slot. Make sure that the dummy
module engages in the slot correctly.
8.6.2
Server Blade Pentium
®
M with attached PCI
Module
Depending on the desired configuration, a maximum of 10 server blades
Pentium
®
M with attached PCI module can be installed in the Blade Server
System. One server blades Pentium
®
M with attached PCI module occupies two
slots on the front side of the server system.
V
CAUTION!
Observe the safety information and the information on handling electro-
static-sensitive components in the section “Components With Electro-
static Sensitive Devices” on page 18.
Server blades can be extremely sensitive to electrostatic discharge and
must always be handled carefully. Place it with the component side up on
a non-conductive, antistatic surface. Do not slide the server blade over
any surface.
I
A server blade expanded with a PCI module cannot be installed in the
slot numbers 10 and 20.
Ê
Remove the cable support from the associated support brackets on the front
fan module (see section “Replacing the Front Fan Module” on page 126).
