Fujitsu PRIMERGY 200, Operating Manual

Page: 61 / 94

RemoteView chipdisk System expansions for tower server
A26361-K632-Z100-1-7619
53
Ê Replace the left-hand side cover (see " Assembling the server ").
So that the RemoteView chipdisk can be started automatically later, enter the chipdisk parameters
in the
BIOS Setup
and boot once from the chipdisk with it. Proceed as follows:
Ê
Start the server and invoke BIOS Setup .
Ê
Enter the chipdisk parameters under
Hard Disk 1
. Instructions are provided in the Technical
Manual for the system board or in the "BIOS Setup" manual.
Ê
Save the setting and terminate BIOS Setup .
The server boots MS-DOS and RemoteView from the chipdisk.
i
If the RemoteView software is not yet installed on the chipdisk, install the software as
described in the manual for RemoteView
Ê
To terminate RemoteView , use the menu item Boot Original OS .
The server boots the standard operating system. How to operate RemoteView is described in the
corresponding documentation of RemoteView.
Removing a RemoteView chipdisk
Ê
Remove the left-hand side cover (see " Opening the server ").
Ê
Disconnect the cables from the chipdisk.
1
1
2
2b
2a
2c
Ê Remove the screw (1) and take out the ventilation plate with the chipdisk mounted on it (2).