Fujitsu PRIMEQUEST 400 Series, Installation Manual, Page: 237 / 446

C122-E001-10EN 4-51
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
2
From the left-side menu in Figure 4.9 , select "Novell AppArmor" and press
the [Tab] key.
Next, from the right-side menu, select "Edit Profile" and press the [Enter] key.
Figure 4.9 Novell AppArmor- select screen
3 Use the [Tab] key to move to "Profile Name," and check for the active syslog
daemon under "Profile Name." The active syslog daemon is the one that was
confirmed in step 1.
If you do not find the active syslog daemon under "Profile Name," the subsequent
settings need not be made. In this case, select "Abort" from the bottom menu, and
press the [Enter] key to exit from this window. Then, select "Quit" from the
bottom menu, and press the [Enter] key to quit YaST.
If you find the active syslog daemon under "Profile Name," select the name of the
syslog daemon. Then, press the [Tab] key to select "Next" from the bottom menu,
and press the [Enter] key.