Fujitsu Oracle M10-1, Service Manual

Page: 65 / 254

--------------------------------
0: /pci@8000/pci@4/pci@0/pci@0/scsi@0/iport@f/disk@w500000e01fb332a2,0
HDD_2 c0t50000393B81B4D7Ad0 TOSHIBA MBF2600RC 3706 <--
(3)
Physical path
--------------------------------
0: /pci@8000/pci@4/pci@0/pci@0/scsi@0/iport@f/disk@w50000393b81b4d7a,0
Note - Unless the system has a redundant configuration, the data on the internal disk will be
lost. Thus, perform this operation only after backing up the data in advance. In addition,
active/hot maintenance of the boot device in a non-redundant configuration cannot be
performed.
# svcs hotplug ← If the STATE is disabled, enable the service.
#
svcadm enable hotplug ←
Enables the hotplug service.
#
cfgadm -a
# cfgadm -c unconfigure Ap_ID
5.4.2 Releasing an internal disk from the system
To use the hot plug function, the hotplug service of Oracle Solaris needs to be
enabled. Check the status of the service. If it is disabled, enable the hotplug service in
the following procedure. The hot plug function is available only on the control
domain and root domain.
For details on the cfgadm command used here, see "2 Dynamically Configuring
Devices" in the Managing Devices in Oracle Solaris 11.2 or "Dynamically Configuring
Devices (Tasks)" in the Oracle Solaris Administration: Devices and File Systems .
1.
Execute the cfgadm command to check the configuration of the internal disk.
If you replace or reduce an internal disk, use the cfgadm -a command to check
the Ap_ID of the disk requiring maintenance and make a note of it. The Ap_ID
refers to a string such as "c4::dsk/c4t5000039428298FFEd0".
If you expand an internal disk, use the cfgadm -a command to check the number
of disks mounted.
2.
Stop all applications from using the internal disk.
3. Execute the cfgadm command to release the internal disk requiring
maintenance from the system.
Enter the Ap_ID you noted in advance.
4. Execute the cfgadm command to confirm that the internal disk requiring
maintenance is disconnected.
The disconnected internal disk is displayed as "unconfigured."
Chapter 5 Preparations Required for Maintenance 51