Fujitsu Oracle M10-1, Service Manual

Page: 146 / 254

Note - Place the removed internal disk on the grounded antistatic ESD mat.
Note - When you reduce an internal disk, install the filler unit into the slot from which you
removed the internal disk.
Caution - Do not attempt to insert an internal disk into a slot when the lever is closed.
Otherwise, the internal disk could jam and prove difficult to remove.
Note - When expanding an internal disk, remove the filler unit of the internal disk from the
slot into which you will install the internal disk.
Caution - Do not force the internal disk into the slot. Using excessive force may
damage the component or the chassis.
Figure 9-3
Removing an internal disk
3. Carefully remove an internal disk from its slot.
9.4 Installing an Internal Disk
This section describes the procedure for installing an internal disk. Perform
expansion using the same procedure.
1. Open the lever and hold the internal disk.
2.
Carefully insert the internal disk into the slot.
Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021 132